 |
1.
SURFACE PREPARATION
For extremely soiled oily areas: use one part degreaser and one part water. Use a scrub brush and rinse. |
 |
4.
FLAKE APPLICATION
Disperse flakes over wet surface for mosaic surface. Repeat Steps 3 and 4 until entire floor is completed. Add non-slip aluminum-oxide as desired. |
 |
2.
SPRAY & RINSE
Spray entire area with 1 part prep solution to 4 parts water mix. EPOXY-COAT may be applied 6 hours after surface preparation. Shot blasting or diamond grinding acceptable in PLACE of prep solution.
|
 |
5.
DRY TIME & MAINTENANCE
Your new EPOXY-COAT floor is ready for light foot traffic in as little as 18 hours; heavy traffic in 24 hours. Easily cleaned with a mild detergent. |
 |
3.
MIX & APPLY
Mix the enclosed contents in this bucket (2 parts “A” to 1 part “B”) for approximately 3 minutes. Cut in perimeter of floor with cut-in brush and apply EPOXY-COAT. |
|
|
